Make a Purple Train TapeBlock
To make a foam train with a light up funnel
VIDEOTrainPurple
Material
- 1 Rectangular foam block
- 1-2mm Foam Sheet
- Light Emitting Diodes (LED)
- Battery Holder with 2 pins
- 3v Coin Cell Battery
- Conductive Tape
- Eyes
- Beads for decoration
- 1mm foam sheet
- 4 wheels (discs)
Instruction
- Take a rectangular foam block
- Take the two legs of an LED and split them apart until the LED will sit flat on a foam block.
- Orientate the LED legs so they run down the centre of long side of the block. Place the LED about 1-2cm from one end
- Wrap a piece of conductive tape over the top of one legs of the LED legs and take it down the front of the block, along the underside and half way up the short side which is the back of the block
- Wrap a second piece of conductive tape over the top of the second leg of the LED running along the long side and around the corner and halfway down the back of the short side of the block. Make a 1cm gap between the two pieces of tape.
- Insert the battery holder and battery with one pin in each of the pieces of tape.
- Cut a piece of 1mm EVA foam into a rectangle to make a cabin.
- Stick the 1mm foam on the two sides of the long side of the block. Stick it at the end away from the LED
- Stick the wheels front and back on both sides.
- Decorate the train
Problem Solving
- If the LED TapeBlock is not working check that the legs on the LED are touching conductive tape
- Check that the LED is the correct direction